| Assay Method Information | |
| | Luminescence-Based ABL Kinase Assay (Km ATP) |
| Description: | Kinase activity of ABL1 was measured using the ADP-Glo system (Promega), which measures formation of ADP using a luminescence-based method. Compounds were serially diluted in DMSO. 20 nL of compound or DMSO only (high control, HC) were added to a 384-well plate (OptiPlate-384, PerkinElmer) using an Echo550 liquid handler (Labcyte). 15 μL of kinase solution (10 mM MgCl2, 0.01% Brij-35, 2 mM DTT, 0.05% BSA, 1 mM EGTA, 50 mM HEPES pH 7.5, and 3.325 nM ABL1 [Carna Biosciences]) were added to each well of the 384-well plate containing the compounds. No enzyme control wells were included (low control, LC). The plate was incubated at room temperature for 30 minutes. 5 μL of a second solution containing 10 mM MgCl2, 0.01% Brij-35, 2 mM DTT, 0.05% BSA, 1 mM EGTA, 50 mM HEPES pH 7.5, 6 μM Peptide 2 (Perkin Elmer, Cat No 760346), and 40 μM ATP were added to each well to start the kinase reaction. The plate was incubated for 90 minutes at room temperature. 20 μL of ADP-Glo reagent (Promega) were then added to each well and the plate was incubated for 40 minutes at room temperature. 40 μL of kinase detection reagent (Promega) was added to each well and the plate was incubated for an additional 45 minutes at room temperature. During this step, ADP was converted to ATP, a substrate for luciferase, to produce luminescence signal. Luminescence was measured on an Envision plate reader (Perkin Elmer). Luminescence signal positively correlates with kinase activity. The percent kinase activity was calculated as follows: percent kinase activity=100×(LumSample−LumLC)/(LumHC−LumLC). As noted above, DMSO only and no enzyme wells were used as high and low controls, respectively. IC50 values were calculated using the XLFit software. |
| Affinity data for this assay | |
|---|---|
| If you find an error in this entry please send us an E-mail | |