| Assay Method Information | |
| | In Vitro Assay for the Inhibition of BTK Kinase Activity |
| Description: | 1: Test Principle:Mobility-Shift Assay, which is microfluidic chip technology, applies the basic concept of capillary electrophoresis to microfluidic environments. The substrate used for the experiment is a polypeptide with a fluorescent label. Under the action of enzyme in the reaction system, the substrate is transformed into a product, and the charge the substrate carries also changes accordingly. The use of the charge difference between the substrate and the product involved in Mobility-Shift Assay achieves the separating of the two, and they are tested respectively. The test results are expressed by conversion rates.2: Test Method:(1) preparation of samples to be tested: diluted with 100% DMSO to 50 times the final concentration of the reaction, i.e. 25 μmol/L;(2) dilution: 25 μmol/L is the initial concentration, then diluted with 4 times the concentration and diluted with 10 concentration gradients;(3) 100% DMSO was added to the positive control well and the negative control well, respectively;(4) the prepared compounds with 10 concentrations were diluted 10-fold with 1 xkinase buffer, respectively; wherein, the kinase buffer contained hydroxyethyl piperazine ethanesulfonic acid at a concentration of 50 mmol/L and a pH of 7.5, 0.01% dodecyl polyethylene glycol ether, 10 mmol/L magnesium chloride, 2 mmol/L dithiothreitol;(5) preparation of 2.5×enzyme solution: the kinase was added to 1×kinase buffer to form 2.5×enzyme solution;(6) preparation of 2.5×substrate solution: FAM-labeled polypeptide and ATP were added to the 1 xkinase buffer to form 2.5×substrate solution; (7) addition of the enzyme solution to the 384-well plate: 5 μl of 5×compound dissolved in 10% DMSO contained in the 384-well reaction plate, then 10 μl of 2.5×enzyme solution was added, the obtained system was incubated for 10 minutes at room temperature;(8) addition of the substrate solution to the 384-well plate: 10 μl of 2.5×substrate solution was added to the 384-well reaction plate;(9) kinase reaction and termination: after incubation at 28° C. for 1 hour, 25 μl stop solution was added to terminate the reaction; wherein, the stop solution contained hydroxyethyl piperazine ethanesulfonic acid at a concentration of 100 mmol/L and a pH of 7.5, 0.015% dodecyl polyethylene glycol ether, 0.2% surface reagent No. 3, 20 mmol/L ethylenediaminetetraacetic acid; (10) Caliper data reading: conversion rate data was read from Caliper. |
| Affinity data for this assay | |
|---|---|
| If you find an error in this entry please send us an E-mail | |