| Assay Method Information | |
| | Test of Small Molecule Compounds for Inhibiting the Activity of VEGFR-2 Kinase |
| Description: | 1. Dilution of the compound: a total of 12 concentrations were obtained using a 4-fold gradient dilution from the highest concentration of 10000 nM (the maximum final concentration of the drug used in this experiment is 10000 nM, and the minimum final concentration is 0.002384 nM),2. 2.5 μl of the gradient-diluted compounds was taken with a transfer pipette to a 384-well plate,3. Addition of enzyme: 5 μl of 2×VEGFR-2 kinase was taken with a transfer pipette to the corresponding reaction well of the 384-well plate, which was mixed and pre-reacted at room temperature for 30 min,4. 2.5 μl of 4× substrate/ATP Mix was taken with a transfer pipette to the corresponding reaction well of the 384-well plate,5. Negative control: 2.5 μl/well 4× substrate/ATP Mix and 7.5 μl 1× Kinase Assay Buffer were added to the wells of the 384-well plate,Positive control: 2.5 μl/well 4× substrate/ATP Mix, 2.5 μl/well 1× Kinase Assay Buffer containing 4% DMSO, and 5 μl/well 2×VEGFR-2 solution were added to the 384-well plate. The final concentration of DMSO in the reaction system is 4%,6. The mixture was mixed well and then centrifuged and reacted at room temperature in dark for 60 min,7. Termination of the enzymatic reaction: 5 μl of 4× Stop solution was taken with a transfer pipette to the wells of the 384-well plate, mixed and then centrifuged, and reacted at room temperature for 5 min,8. Development of the reaction: 5 μl of 4× Detection Mix was taken with a transfer pipette to the wells of the 384-well plate for color development, and the mixture was mixed and then centrifuged and reacted at room temperature for 60 min,9. The 384-well plate was placed into the Envision plate reader and the signal was detected using the appropriate program,10. Analysis and processing of the raw data:The drug concentrations and the corresponding inhibition rates were input into GraphPad Prism5 for calculation, and the inhibition rate of the compound was calculated as follows: inhibition rate (%)=[1−(experimental well reading value−negative control well reading value)/(positive control well reading value−negative control well reading value)]×100%. Processing with GraphPad Prism5 software yielded the corresponding IC50 value (the concentration of the compound at which 50% of the highest inhibition of the enzyme is achieved). |
| Affinity data for this assay | |
|---|---|
| If you find an error in this entry please send us an E-mail | |